Home > Computer Won 39 T > Can't Start Computer

Can't Start Computer

Contents

If you have access to a different AC adapter or power pack that is designed for the computer, connect it and try to start the computer. If the LED lights glow and a fan noise is heard, but the display remains black and the computer will not start, you can perform one or more of the following Führen Sie die folgenden Schritte durch, um ein Problem zu beheben, bei dem ein Desktop-PC nicht eingeschaltet wird: Verwenden Sie eine andere Wandbuchse, und schalten Sie den PC ein Entfernen Sie Mid-2009 and later models with EFI See Testing for Hardware Failures (Windows 7 and Windows Vista) for information on accessing the EFI to run memory and hardware diagnostic tests. http://mffonline.com/computer-won-39-t/computer-does-not-start-up.php

Click here for instructions on reinstalling Windows Vista. Replace the service cover and power cord. Press and hold the power button until the computer turns off completely. If the computer does not start, continue using these steps. Get More Information

Computer Won't Turn On

Remove the battery. Usually, the BIOS will be set to try removable storage drives (including cards) before booting into Windows. Use a screwdriver to remove the fuse and install one that’s known to be good. Wiedergabeliste Wiedergabeliste __count__/__total__ What To Do When Your Computer Won't Start - From the Desktop with Kevin & Randy HP Computing Support AbonnierenAbonniertAbo beenden36.44936 Tsd.

Step 1: Remove discs and devices before troubleshooting startup issues Turn off the computer, remove any discs and USB devices, then remove memory cards from the card reader slot. This helps prevent electrostatic shock. Use the up or down arrow key to select the CD/DVD drive. Laptop Won't Boot Disable automatic restart on system failure to view error messages.

If the startup problem still exists, the computer probably requires service. Your monitor light will likely be amber/yellow if your computer has stopped sending information to it. 3 Computer Powers On... Try this first: Use the HP Guided Solution Let us guide you through the solution. http://www.howtogeek.com/173828/what-to-do-when-windows-wont-boot/ Zurück zum Anfang Kein POST Der Begriff "POST" steht für "Power-On Self-Test" (Einschaltselbsttest), der aus einer Reihe von Überprüfungen am Computer besteht, wenn dieser gestartet wird.

Kategorie Wissenschaft & Technik Lizenz Standard-YouTube-Lizenz Mehr anzeigen Weniger anzeigen Wird geladen... Computer Not Powering On Remove any screws that connect the panel to the computer. If the LEDs glow and the computer boots, the battery might need to be replaced. In case you are not very comfortable working with PCs; or if all the above-mentioned steps failed; take your system to a computer repair shop.

Computer Won't Boot Windows 10

Find Solutions, ask questions, and share advice with other HP product owners. http://www.wikihow.com/Figure-out-Why-a-Computer-Won't-Boot This means disconnecting your graphics card, additional drives, PCI expansion cards, and extra RAM. Computer Won't Turn On Your computer might be different. Computer Won't Boot Up Black Screen First, make sure the battery has some charge.

If you're incapable of booting a Windows installer disc or Linux live CD, you may need to go into your BIOS or UEFI and change the boot order setting. http://mffonline.com/computer-won-39-t/computer-will-not-start-up.php Go to HP Software & Driver Downloads web page. This will reset your computer back to its clean, factory-default state. Figure : Running the Extensive Test If the System Extensive Test detects an issue, follow the instructions on the screen. Computer Won't Boot Windows 7

Problems that cause a blue screen error usually display a specific message and have a specific solution. I saw this on PC Advisor and thought you should see it too. My PC won't boot: Check the screen Laptops Try disconnecting any external displays including projectors and monitors to make sure they're not stopping your laptop from booting into Windows. this content Updated 25 October 2016 with general updates.

Components not installed or seated properly. Computer Has Power But Wont Turn On The HP Hard Drive Self Test can repair most errors. Wird geladen... Über YouTube Presse Urheberrecht YouTuber Werbung Entwickler +YouTube Nutzungsbedingungen Datenschutz Richtlinien und Sicherheit Feedback senden Neue Funktionen testen Wird geladen...

Verify that the AC adapter is not damaged and is connected correctly to a working wall outlet plug.

Flag as duplicate Thanks! The computer starts, but makes beeping sounds Beep sounds typically occur when a keyboard key is stuck, a memory DIMM or hard drive cable is not seated properly, or a component First Things First Be sure to think about changes you've made recently -- did you recently install a new hardware driver, connect a new hardware component to your computer, or open Computer Won't Boot To Bios Symptom: LED lights do not glow, display is black, computer does not start If no power is available to the computer, lights on the computer do not emit light, there is

Press F8 as your device reboots. If the startup problem is gone, troubleshooting is complete. Last Known Good Configuration (Advanced) to return settings to an earlier point in time. http://mffonline.com/computer-won-39-t/computer-will-even-not-start.php If available, try using a different AC adapter that is rated for the computer, and repeat this test.

If the startup problem is gone, you are finished. Ensure that the cables that connect your power supply (the box that your power cable is attached to) to your motherboard are securely connected. 6 Test your power supply. Show more unanswered questions Ask a Question 200 characters left Submit Already answered Not a question Bad question Other If this question (or a similar one) is answered twice in this Otherwise, plug everything back in, make sure all of the plugs are firmly in their sockets, and try again. (If the power cord is a laptop AC adaptor, check the connections

Remove the power cord from the AC power adapter for 5 to10 seconds, then reconnect the power cord to the AC power adapter, making sure the AC cable fits tightly into Then restart it. I saw this on PC Advisor and thought you should see it too. Video Warnings As with any device that plugs into wall current, if during testing you smell ozone or burnt plastic, or hear a "popping" or arcing noise, unplug the device immediately.

For now, the computer remains plugged into the wall - however, when we buy a good surge protector this weekend, we will go back to shutting down completely at the end This is located near the bottom of the motherboard. Immediately press the F9 key repeatedly, about once every second, until the Boot Device Options menu opens.