Home > Dell Dimension > Dell Dimension E521 No USB/bad Cable

Dell Dimension E521 No USB/bad Cable

Contents

Bad error-correction code (ECC) on disk read — See "Drive Problems" in your Owner's Manual. I posted the Powered USB trick previously. Continue until you have identified a faulty module or reinstalled all modules without error.If available, install properly working memory of the same type into your computer (see Installing Memory).If the problem I tested the hard drive with a USB to SATA/IDE adapter to my laptop and it works fine. click site

Wierd Jimbo Hanna February 19, 2008 at 4:38 pm Reply I had the same problem, replaced the power supply and now the diagnostic lights are on (YYYG) and I have Ask a question and give support. in the USA Local time:05:57 PM Posted 20 September 2010 - 11:06 AM Hello and welcome to Bleepingcomputer. http://support.dell.com/support/edocs/systems/opgx260/en/ug/solvprob.htm#1167139 Good Luck to you all! John219 January 24, 2009 at 4:39 am Reply My Dell Precision 350 won't start up. http://www.techspot.com/community/topics/dell-dimension-e521-no-usb-bad-cable.104339/

Dell Dimension E521 Error Lights 3 And 4

NOTE: Write down any error codes and problem descriptions exactly as they appear and follow the instructions on the screen. To learn more and to read the lawsuit, click here. A driver is a program that controls a device such as a printer, mouse, or keyboard. test powersupply and HD and both are dead. 1.5 hours with dell chat, yes Indian, to get powersupply and HD replacement sent to my work, since under warranty.

The moral of the story: try the simple stuff first. So I toggled the surge protector on and off, and I checked the USB ports for dust / bent pins but they are fine. And tonight I thought it finally had me. So I can use the power button to shut down the laptop and then restart it which fires up right away, but only runs for a few minutes and then shuts

No more orange lights. Ensure that the voltage selection switch is set to match the AC power at your location (if applicable). Taking the plug out the back counting to five and then plugging it in again. help please Vic October 2, 2008 at 9:22 pm Reply Hi there!

Where are the USB controllers located on these machines? My problem ended up being the 3V battery. So far all we've gotten to is "press check if the power button is not broken. How do I get past the /windows/system32/config/windows ?

Dell Dimension E521 Motherboard

By the way, if the weekend away doesn't work I think I will try to teach the 8100 to fly. A possible floppy or hard drive failure has occurred. Dell Dimension E521 Error Lights 3 And 4 Extended Test Performs a thorough check of devices. The technician can find this using your service tag number) NH720 Motherboard Service Kit for Prescott CPUs TJ946 Motherboard Service Kit for Cedar Mill, Smithfield, and Presler CPUs Message Edited by

This test typically takes an hour or more and requires you to answer questions periodically. get redirected here I also tried the original ethernet cable between the modem and another computer and it worked fine. Click Finish and restart your computer. Thank you all for sharing your experiences.

Turning on the space heater must have been causing a small power surge. Had the same problem on my Dell Dimension 3000 and now everything is just back to normal. Costa Rica Kid January 25, 2008 at 9:00 pm Reply I am Fitted it back in securely, and the system worked perfectly. Help January 3, 2009 at 6:36 pm Reply Hi Everyone, I had the same problem. navigate to this website Ubuntu takes about 1 minute to load into live desktop environment and once it does I begin installing Ubuntu (typical install with all the usual prompts, questions, etc).

Well after that, I tried restarting the 8200 after I plugged in it's peripherals and it wouldn't start up…. This reduces the size and makes it a tighter fit with the pin it mates to on the motherboard. The power button is not turning on, when I press start button.

Here are things I have noticed when it does this. #1.

Those connectors can also be expanded and be larger than the pins they are supposed to be making a connection to. I'll pull the original supply and blow it out etc and see if I can resurect it. Please suggest me something. My guess is that my DELL DIMENSION E310 will do this again in a week or so.

I looked at the USB ports, and they looked ok except for a little dust. Small fix for big problem. He said it worked great for one day and then back to the original problem , just a black screen on bootup. http://mffonline.com/dell-dimension/dell-dimension-4300-vs-dell-dimension-8100.php A driver acts as a translator between the device and any other programs that use the device.

RSS ALL ARTICLES FEATURES ONLY TRIVIA Search The How-To Geek Forums Have Migrated to Discourse How-To Geek Forums / Windows Vista Ethernet port on Dell PC not working (11 posts)