Home > Hard Drive > Can An Emachines HD Be Swapped Into A Dell?

Can An Emachines HD Be Swapped Into A Dell?

Contents

It is usually only necessary if you want to add more IDE drives than your computer will support with it's two built-in channels. A different approach, before you removed the cables unfortunately, would have been to run DBan to erase the hard drive, and then just leave it in there. Some points to bear in mind: Only swap when the OS is really shutdown. However, I am still stumped. http://mffonline.com/hard-drive/dell-not-recognising-2nd-hdd.php

Is the HD recognized in BIOS ? I knew something was wrong. To learn more and to read the lawsuit, click here. If that sounds like too much, then perhaps it's time to find a technician orĀ at least a techy friend. my review here

Can I Put My Hard Drive In Another Computer

I also would like to note I put the 20 gig hard drive dual booting XP and UBUNTU 8.10 into the emachine and it loads up asking which OS to boot, I would prefer to go SATA all the way. I'm not fussed about buying licenses for both PCs, but would I have any problems with drivers due to the different serial numbers of the components? I'm so happy I found your website.

I read your page on installing and cloning my hard drives. Then reboot and reconnect LAN and you are good to go. http://www.bleepingcomputer.com/forums/t/2520/how-did-i-get-infected/Forum Rules, The BC Welcome Guide 167 @ June 2015 Back to top #7 ummhasan ummhasan Topic Starter Members 155 posts OFFLINE Gender:Female Location:Michigan Local time:04:28 PM Posted 01 September Adding Old Hard Drive To New Computer I'll be back for more later.

Already have an account? Install Old Hard Drive In New Computer Reply Esakkimuthu May 29, 2013 at 12:07 am Hi, I'm installing Wind 2003 server & some applications in a hard disk of a machine. Copyright 1990-2003 Dell Computer Corp. is there a place to download it or what should i do?

Reply Tom says: January 24, 2009 at 4:40 am Hi I am trying to install a new sata drive onto my pc. Can I Use My Old Harddrive In A New Computer It's an e-machine. If you are adding a second drive, just pick any empty drive bay - one a bit below the current drive might work best, because it will make it easier to i changed the primary drive in the bios to the ide hard drive , still couldnt get passed start up mode.

Install Old Hard Drive In New Computer

Now that SATA is becoming much more prevalent than IDE, it is becoming a lot less likely that you will need to worry about jumpers during this process. read the full info here I've attempted the startup repair multiple times and each time it fails. Can I Put My Hard Drive In Another Computer Username Forum Password I've forgotten my password Remember me This is not recommended for shared computers Sign in anonymously Don't add me to the active users list Privacy Policy

ERROR Swapping Hard Drives Between Computers Thanks, hope to hear from you or another one of the commenters soon.

Thanks for the instructions! this content We have tested 700 of these machines in preparation for suit against Mfg. My next Challange!!! Should I simply add jumpers and format the second drive? Moving Hard Drive To New Computer Windows 10

Thanks Reply Tom says: December 20, 2008 at 10:19 pm Without getting involved in a conversation about whether or not myself or anyone else can understand the lingo here…I'm simply attempting However it is not appearing in ‘My Computer', even though I'm using Windows ME? The ribbon cable is usually quite easy to remove. http://mffonline.com/hard-drive/dell-not-recognizing-hdd.php Just rock it back and forth (lengthwise along the narrow side of the drive), taking care not to rip the connector off the drive.

Reply Mark says: January 31, 2008 at 2:43 am My old hard drive crashed. Transfer Hard Drive To New Computer Without Reinstalling Windows If the drives are not being recognized, check that both power and data cables are in tightly (including the motherboard end for the data cables), and that the jumpers are set The Drive is found under the device manager under mass storage but not in disk manager.

Thanks!!

Reply James Scholes says: June 23, 2009 at 2:47 pm Hi, I have a drive mounted in an external enclosure, on which the power supply has gone dead. If you are confident in yourself and would like to save the money a computer guy would charge to do it, go ahead and do it yourself. Any hardware differences will be resolved by the OS. What Kind Of Power Connector Does A Floppy Disk Drive Typically Use? Register a free account to unlock additional features at BleepingComputer.com Welcome to BleepingComputer, a free community where people like yourself come together to discuss and learn how to use their computers.

If I buy a foreclosure at courthouse auction, am I in any way responsible for debt on the property? How should I erase my hard drive before I give it away? The hard drive and memory are good, as is the CPU and fan... http://mffonline.com/hard-drive/dell-s-hdd-bay-option.php Edited by ummhasan, 01 September 2013 - 11:49 AM.

I just installed a 1TB HD via sata controller card, to my Dell pc. Reply LUIS RESTO says: June 24, 2009 at 11:06 pm DAVID YOU ARE THE BEST BRO I want say Thanks so much for this post this post help me alot thanks Thanks alot. and ur write he DIDNT start off with TAKE drive out of box… jeeees….

Reply Barbara says: February 21, 2009 at 12:30 am i have a 6g hard drive, but i have a 40 g new hard drive. Ask a Question See Latest Posts TechSpot Forums are dedicated to computer enthusiasts and power users. As I write this, 500gb of new hard disk space is slowly formating into existence, and soon my now dwarfish primary disk will have space to spare. This is especially the case if you are not using a touch screen.

This will prevent frustrations about losing programs after you have already formatted your computer. I have installed on the D drive Windows XP, I access this by entering the BIOS and making 2 changes. For some people, such sketches help to put everything back when you are done. Im very sure I have it connected correctly, but when I boot up and try to enter the setup it takes a very long time and eventually goes black bar a

Do I have a problem or is this normal if it's not normal what can I do about it ? In the article, it mentioned that the PC should not be plugged into the internet until XP SP3 is installed; they then provided the link to d/l the SP3 patch. If it were mine at this point in time I would probably put Windows 8 on the computer and install "Classic Shell" to make it work like Windows 7. I did notice now that the device manager is not seeing the SM Bus device and I'm now runing an intel chipset utility which may fix some problems - not sure