Home > Not Detected > Bios Can't Read Drives On Off Board Controller

Bios Can't Read Drives On Off Board Controller

Contents

Flag Permalink This was helpful (1) Collapse - It's all about the controllers by DJPython / July 22, 2005 5:53 AM PDT In reply to: Mixing SATA and IDE drives in I have two SATA drives as my main drives, and I have two IDE drives (one refuses to operate), so I installed the one IDE drive into my system, and have Software ▼ Security and Virus Office Software PC Gaming See More... HDD. Check This Out

But if it is not spinning up (is it) then it could be dead. The SATA port is NOT enabled 2. when i press f1 it says no boot device available please kindly help me April 12, 2013 Joe if you can help, I have a dell inspiron 15R with a 320g And to answer your question, the data is very valuable.

Sata Hard Drive Not Detected In Bios Or Setup

I don't want to be slotting out/in the harddrive every time to get it to work as this is not going to do the connections any good at all. It is not a boot record or MBR issue.The freeze method works sometimes for the click of death and other mechanical failures.What you have is a dead hard drive controller board. October 26, 2009 Dave Sounds like something has happened to the boot loader. I hope you can assist me.

Can you hear or feel the drive spinning up? scotland2109-07-2012, 10:24 AMYou would only remove the drives out of the equation and if you need to use them you still have an issue if one of the drives is faulty. Drive F: still appears on my Computer and I can now access Shared Files between both computers which I couldn't do after installing MaxBlast5. Hdd Not Detected In Bios Fix Improve speed at all?

i thought it would be helpful to those wiv the same problemshope this helpsbabs Flag Permalink This was helpful (0) Collapse - SATA & IDE Combination Troubles--but w/ SATA adapters IDE's Most likely this disk was giving errors for a while. 2) Always make a backup of your data. RonPaul2k12Apr 18, 2012, 8:10 AM Well I tried two different 64-bit downloads on that page. http://www.techrepublic.com/forums/discussions/how-can-i-fix-when-a-hard-drive-is-not-recognized-by-bios/ My "new" problem is with the internet connection.

I always recommend updating an older computer if it is within your budget. Bios Can't Detect Sata Hard Drive is the seller of record and licensee in the Americas of SanDisk® products. by nelchael_com / November 22, 2006 5:48 AM PST In reply to: Same problem here... __[ In English, resume/summary ]______________________I get a HD SATA and want turn it the Primary Boot please throw some light..

Hard Disk Not Detected In Bios How To Recover Data

Report • #2 OtheHill May 14, 2012 at 14:59:55 Get nliteOS from the link below. http://knowledge.seagate.com/articles/en_US/FAQ/168595en/ Ok so here it goes. Sata Hard Drive Not Detected In Bios Or Setup Flag Permalink This was helpful (0) Collapse - Mixing SATA and IDE drives in a system? Hard Disk Not Detected In Bios Laptop You should experiment with "other", SCSI, hd1, hd2 or whatever your BIOS offers as bootable devices and see which one applies to your RAID.

Terms of Use | Trademarks | Privacy | Cookies Western Digital Technologies, Inc. his comment is here The HDD spins (that means power is clearly working), but the BIOS just doesn't pick it up. If you do not hear or feel the hard drive spinning, the drive did not start.     If you cannot determine whether the drive is spinning: Boot the computer and listen carefully.Shut Such opinions may not be accurate and they are to be used at your own risk. How To Get Bios To Recognize Hard Drive

Drive not getting enough power, try different power supply If jumpers are on the drive, it may be in some weird diagnostic mode. Dell says to use cable select option which I finally did after being coached by Maxtor's install instructions to use [master] option on the Primary and [none] on the Secondary… didn't Col 0Votes Share Flag Collapse - As I and OhSmeg Said by TheChas · 7 years ago In reply to BIOS and motherboard are ... http://mffonline.com/not-detected/bios-cannot-see-drives-on-ide2-3.php You cannot mix the two on the same controller to my knowlege.

Serial ATA cables, in particular, can sometimes fall out of their connection. How To Repair Hard Disk Not Detected Yes No Your rating has been submitted, please tell us how we can make this answer more useful. So to rule things out try these: Try adding just one drive, see if it's properly detected.

http://www.asus.nl/Motherboards/Intel_Socket_2011/Rampage_IV_Extreme/#overview Nodens08-30-2012, 09:10 PMLol I don't know what the guys at ubuntu maintenance are smoking but apparently they made dmraid assemble on a weird device node name:P ddf1_New_VD instead of good

Nodens08-30-2012, 09:41 PMOne more question. by rbird / July 22, 2005 11:48 PM PDT In reply to: Mixing SATA and IDE drives in a system? Is it a faulty harddrive or something not set correctly. Bios Doesn't Detect Hard Drive Laptop any idea on how to detect and recover files from it.

Note: "The b####.bin file is the IDE (non-RAID) BIOS. today i found that my older WD isnt working/spining just as no power is going into it i tried to change cables but still, its the hdd fault. Before anymore problems occur, (which i hope they dont), id like to thank everyone who has helped me. http://mffonline.com/not-detected/bios-can-t-detect-drives.php to enable the partition or volume,restart the computor.) did the restart still no luck.question 1what is the best program to get back original files i had?question 2would it be best to

Would I still be able to run the computer with just the Windows? Clicked install and bang, windows pop up saying i shouldnt install the drive. I can hear disk working but not light is on indicator of external enclouser. T Status BAD” mean when reported by the BIOS about my hard disk?

I had only 2 days ago updated the Bois. Join the community here, it only takes a minute. Enhanced mode device support must be set on to use a mixed device configuration. I would definitely make sure you have a powerful, name-brand PSU in the system.

Join them; it only takes a minute: Sign up Here's how it works: Anybody can ask a question Anybody can answer The best answers are voted up and rise to the Flag Permalink This was helpful (0) Collapse - Same problem here... Jon. Turned off computer, pulled the SATA cable and plugged it back in.

I have a SATA drive as the primary and and IDE slave. Unfortunately, hard drives are a commodity and need to be treated as such. It says RAID in the name of the boot device but I definitely made it first priority. I used an IDE to SATA converter to hook it up.