the surprising thing is that, it was working all these years until I touched it for RAM upgrade. In the article, it mentioned that the PC should not be plugged into the internet until XP SP3 is installed; they then provided the link to d/l the SP3 patch. Further Reading Well, I hope that’s explained the whole IDE thing a bit more clearly. TechRepublic Search GO CXO Cloud Big Data Security Innovation More Software Data Centers Networking Startups Tech & Work All Topics Sections: Photos Videos All Writers Newsletters Forums Resource Library Tech Pro Check This Out
Thank you. Joshcore, if you are blindly defending your precious website PC Mech, then please, at least have a decent reason to do so. Thanks for the instructions! See manual Section 4.8 on p. 4-37.If the BIOS Setup screen cannot detect your IDE unit, you MIGHT try moving your SATA HDD to another SATA port just in case it http://www.techspot.com/community/topics/bios-cannot-see-drives-on-ide2-3.38048/
Ide Hard Drive Not Detected In Bios
Different jumper settings. Reply Tyler Thompson says: September 10, 2007 at 2:10 pm David, When you clone a drive, it copies it exactly as it were before. or what i'v done wrong?
Computer Doesn't Recognize External Hard Drive I have a basic wd external hard drive. I have a western drive 20gig as the main drive and i just want to use the second for my files. Windows Xp Recognize A 250 Gb Hard Drive As 128 Gb My windows xp does not recognise the 250 gb disk but says its 128gb. Hard Disk Not Detected In Bios Laptop View Related Posts . .
Reply Alejandro says: August 3, 2008 at 8:19 pm I Have A Compaq Presario SR5130NX with a Western Digital Caviar SE (SATA) Hard Drive (Vista). Detecting Ide Drives Problem I have no idea about computers and never opened up the box. Posted On: 03-04-2010, 02:03 PM . It's extremely unlikely the mboard was intially defective - if it does prove to be defective, it's a lot more likely you damaged it (such as by you not disconnecting the
A better power supply may have been damaged rather than not working at all after that like that one did. How To Repair Hard Disk Not Detected View 9 Replies . Others will have a note on the drive label instead: Figure Out Your Existing IDE Scheme It’s more than likely you currently have both a CD-ROM drive and hard disk plugged If not, you can extend it using a controller card just the same way as with IDE.
Detecting Ide Drives Problem
I plugged all three in and my computer screeched at me!!!! Get More Info Make sure that you DO NOT connect wiring for a pair of USB ports to it !No harm is done unless something is plugged into a mis-wired USB port, BUT when Ide Hard Drive Not Detected In Bios If you change that setting in the mboard's bios so the SATA controllers are in an IDE compatible mode of some sort, then the files initially loaded from the Windows 7 Bios Doesn't Detect Ide Hard Drive How To Best Use Two Hard Drives?
I then removed IDE-0 from the list completely, and it told me that it failed to boot, and that it could find no boot record in the CD-DriveI thought that it his comment is here If you are simply installing a secondary drive, boot into Windows. I had no idea that "disk management" section existed 😀 Once i found it i initialized the HD and am currently formatting it. Should i set up the old one as the master and the new as the slave or vice versa? How To Connect Ide Hard Drive To Motherboard
I originally bought my NO NAME computor from him back in December It first went down in March probally from trying to download free music off Kazzaa. Internal Hard Disk Not Detected Your drive already has been seen by the computer and your just putting it inside. It won't be that bad.
My old computer died but its IDE drive was perfectly fine so it seemed obvious to me to install the old IDE drive into my new computer as a second drive.
Anywhere i can find this, other than my computer? Posted On: 12-18-2007, 11:51 PM . I'm familiar with computers but this is the first dual setup I have seen. Reboot And Select Proper Boot Device Reply Fred says: August 16, 2009 at 2:08 pm Thanks to your excellent instructions I was able to install a new hard drive with only minor pain.
What we're looking for here is a poor cable or connector.You also could try to "fix" a possible dirty connection. I have them reconnected this same way. View 5 Replies . navigate here please lat me know… Thanks Reply Mario says: February 18, 2008 at 5:45 pm Dumb question??… Since the "S" in SATA stands for "serial", can 2 SATA drives be connected in
Is it better to just get the: western digital raptor 36. 7 g 10, 000 rpm drive and just using that or putting the western digital raptor 36. 7 g 10, Think it's just dead?